Other Accessories; Cleaning Instructions - Winplus LM55970 Instructions D'utilisation Et D'entretien

Other Accessories:

The lighting fixture is provided with a plastic cap and a cable bushing. Always refer
to a qualified electrician if re-wiring of power cable is required. After re-wiring, the
plastic cap is used for covering the original opening for the power cable, and the cable
bushing is used for output of the power cable / hardwire.
Troubleshooting:
Issue
The light is
not working
The light is
always ON
The light is ON
without any
identifiable
movement
The light is not ON
despite movement
Maintenance:
CLEANING INSTRUCTIONS: When cleaning, make sure you have unplugged the lighting
fixture and allow it to cool to room temperature. Do not open the retaining clips when
cleaning. The lighting fixture can be cleaned with a feather duster or a soft damp cloth.
You should plug in the lighting fixture after it has been completely dried.
Cause
The light is not plugged in or the Main
switch is OFF
The ambient light sensor is ON and it
switches OFF the light while the ambient
is bright
Continuous movement
in the detection zone
Motion sensor has been switched OFF
The total time the light stays on for is
Time Until Dim plus Time Until Off
Movement occurred (movement behind
wall, movement of a small object in
immediate lamp vicinity, etc.)
Rapid movements are being suppressed
to minimize malfunctioning of light or the
detection zone you have set is too small
The ambient light sensor is ON and it
switches OFF the light while the ambient
is bright
Remedy
Plug in and turn on the Main switch
Change the Switches 5 & 6 to OFF, or
other appropriate settings
Change Switches 1 & 2 settings to
shorter distance, such as Very Near
Change Switches 9 and 10 to other
appropriate settings
Adjust Switch 3 & 4, and Switch 9 & 10
settings to shorter durations
Change Switches 1 & 2 settings to
shorter distance, such as Very Near
Check Switches 1 & 2 settings
Change the Switches 5 & 6 to OFF, or
other appropriate settings
13