Setting; User Setting; Setting Switches And Their Functions; User Setting Menus - Ikegami ICD-48E Mode D'emploi

5. Setting

5-1. User setting

On this camera, user can make settings of picture quality, synchronization, identification
etc. by himself or herself.
The setup menu is formed in a tree view, and the picture sharpness, synchronization, ID
and others can be set up by on-screen characters. (See the setup tree given in the end
of this manual.)

5-2. Setting switches and their functions

SET UP
U
L R
D
E

5-3. User setting menus

(1)CAMERA ID
(2)SHUTTER
(3)LIGHT CONT.
(4)GAIN
(5)SYNC
(6)MENU LOCK
● Setting Indications and functions common on the setting menu
(1)EXIT
(2)CANCEL
(3)RESET
(4)RET
Select one of these indications and press the E switch.
On the back of the camera there are the pushbutton switches and
display as shown at the left.
UP switch (U):
DOWN switch (D):Setting item selection (down)
RIGHT switch (R): Setting change and setting item selection (right)
LEFT switch (L): Setting change and setting item selection (left)
ENTER (E):
* To enter into the setup mode, keep pressing the E button.
Up to 16 characters can be accepted and displayed.
Switching on and off the CAMERA ID function and presetting ID code
characters.
Setting of high-speed electronic shutter
Selection of high-speed shutter, display of the screen at VARIABLE
mode
Selection of AES or auto iris lens
Setting of back-light compensation as sub-menu
Selection of AGC, HYP-AGC and fix
Selection of synchronization system (INT, LL)
(It is impossible to select LL when the power is not synchronous.)
GENLOCK is selected automatically.
(GENLOCK is not displayed without external sync signal.)
It is possible to adjust the phase on sub-menu.
Setting procedure is locked. (Unlocking: U→R→D→L→U →D→E)
Ending (Saving) the setting mode and returning to the regular display.
Recalling the previously saved settings.
Recalling the factory-settings.
Returning to the preceding setting menu.
Setting item selection (up)
Setting mode call on/off, setting entry
E-5