Tecnoinox FTL4G7 Mode D'emploi page 13

Part 3
Press and turn knob "A" (pic.4) from position "
pressed in.
At the same time, press the ignition button "B" (pic .4) repeatedly until
the pilot flame has lit up.
After the flame has lit, hold the knob down for approximately 10
seconds (count to 20); so, the thermocouple heats up and the safety
valve can be kept open.
To light the main burner on, turn the knob until it reaches the desired
position.
Note: if the piezoelectric device cannot be used, you can alternatively
light the flame by using a match or a gas lighter.
Regarding models FTC4_G7 and FTC8_G7, turn the knob from position
1 to 7 to obtain the desired temperature; the appliance reaches its
maximum temperature in position 7 (~300°C).
The appliance has a fat recollection drawer "V" (pic.2) located on the
front part of the control panel.
In case of overheating (due to improper use or to a faulty component)
the safety thermostat "E" (pic .1), placed at the bottom of the appliance,
will operate. It automatically cuts off the gas supply to the burners.
Turn off the gas cock installed upstream the appliance.
Turning the burner on and off
●
" to " ", keeping it
Fat recollection drawer
Safety thermostat only on model FTC_G7
What to do if the appliance is not going to be used for a long time
For models FTL/R4_G7 and FTL/R8_G7:
Off
TURNING THE BURNER OFF:
Turn the knob from the current position to the "
TURNING THE APPLIANCE OFF:
Turn the knob to the "
Empty the drawer before using the appliance.
When such device operates, close the gas cock placed upstream of the
appliance and inform the after-sales service.
Clean the appliance with soapy water, rinse, dry carefully and apply a
light layer of white mineral oil.
GB / IE - 4
pilot light Burner MAX
" position.
●
" position.
Use
Burner MIN