Troubleshooting - Westinghouse WD32HBB101 Manuel De L'utilisateur

TROUBLESHOOTING

If your TV does not operate normally or cannot be turned on, please check the following
WURXEOHVKRRWLQJ TXHVWLRQV 5HPHPEHU DOVR WR FKHFN DQ\ RWKHU FRQQHFWHG HOHFWURQLF GHYLFH
such as a DVD or Blu-ray player to pinpoint the problem. If the TV still fails to operate
normally, please contact technical support.
The TV does not operate properly
The TV does not respond
when pressing any buttons
TV cannot be switched on
The remote control does not
work
Power is suddenly turned off
The video function does not work
No picture & no sound
Picture appears slowly after
switching on
No or poor color or poor
picture
Horizontal/Vertical bar or
picture shaking
Poor reception on some
channels
Lines or streaks in pictures
No pictures when connecting
HDMI
Pictures appear in wrong
ratio
The audio function does not work
Picture OK but no sound
No output from one of the
speakers
Unusual sound from inside
the TV
No sound when connecting
HDMI
Audio noise
• The TV may freeze up during use. Disconnect the power cord from
the power socket for a few minutes. Reconnect the power cord and
try to operate it again as usual.
• Check that the TV is connected to the power supply.
• Make sure all connected AV devices are switched off before switching
on your TV.
• Check to see if there are any objects between the TV and the remote
control causing an obstruction. Ensure that you are pointing the
remote control directly at the TV.
• Ensure that the batteries are installed with the correct polarity (+ to +,
- to -).
• Install new batteries.
• Check the power of the TV. The power supply maybe interrupted.
• Check if the sleep timer is set.
• Check whether the Auto Standby is activated.
• Check whether the TV is switched on.
• Try another channel. The problem may be caused by the broadcaster.
• 7KLV LV QRUPDO WKH LPDJH LV PXWHG GXULQJ WKH 79 VWDUWXS SURFHVV
Please contact your service centre if the picture has not appeared
after 5 minutes.
• Adjust the settings in the Picture menu.
• Try another channel. The problem may be caused by the broadcaster.
• Check if video cables are connected properly.
• Check for local interference such as an electrical appliance or power
tool.
• 7KH VWDWLRQ RU FDEOH FKDQQHO PD\ EH H[SHULHQFLQJ SUREOHPV WXQH WR
another station.
• Station signal may be weak, reposition the antenna for better
reception.
• Check for sources of possible interference.
• Check antenna (change the position of the antenna.)
• Check if the input source is HDMI1/HDMI2/HDMI3.
• Adjust the Aspect Ratio settings in the SETUP menu or press the
ASPECT button on the remote control.
• Press the VOL +/- buttons.
• Sound muted? Press the MUTE button.
• Try another channel. The problem may be caused by the broadcaster.
• Adjust the Balance settings in the AUDIO menu.
• A change in ambient humidity or temperature may result in an unusual
noise when the TV is switched on or off and does not indicate a fault
with the TV.
• Check if the input source is HDMI1/HDMI2/HDMI3.
• Keep the RF coaxial cable away from the other connected cables.
23
En