Safety And Warnings; How To Install - Velleman PCSU200 Instructions En Bref

SAFETY & WARNINGS
Instruments grounds are interconnected and connected to PC ground. Max. voltage between probe tip and ground: 30V AC+DC at all
times! Before performing any measurement, make sure that the circuit is galvanically seperated from the AC power (mains)!
H
OW TO INSTALL
Minimum system requirements :
• Windows™XP/Vista/7 (*) 32 or 64bit
• VGA display card (1024x768 recommended)
• 10MB free hard disk space.
• Mouse or pointing device.
• Free USB port (1.1 or 2.0)
Download the latest software version from www.velleman.eu
(*) Note: You will need local Administrator privileges to successfully complete the installation, contact
your system administrator for assistance. See also the "ReadME" fi le in the installed folder.
*Microsoft Windows™ XP/VISTA/7 (*) are registered trademarks
nnected to PC grou und. Ma ax. voltage betwee
k th t th e circuit is galvanically s i
If necessary, use a safety isolation transformer.
PC-L
AB
Type PCSU200 in the search box and check the
download section.
• Download the PcLAB200_setup.zip fi le
• Unzip the fi les in a folder on your drive
• Double click the "setup.exe" fi le
An install wizard will guide you trough the complete installation
procedure. Shortcuts to the Pc-Lab200 software can be installed.
200
SOFTWARE
?
5
www.velleman.eu