Connecting The Gps Receiver To A Terminal - Amazone DGPS-A101 Notice De Montage Et D'utilisation

Procedure
3.2
Procedure
V4.20160115
NOTICE
The GPS receiver needs an open view of the sky.
◦ Mount the GPS receiver on the roof of the vehicle cabin.
◦ Avoid obscuring the GPS receiver's view of the sky.
1. Find a suitable place on the vehicle roof. This place should be as far to the front
as possible and in the middle of the vehicle.
2. Use alcohol to clean the place where you will mount the DGPS receiver.
3. Stick the two-sided 3M adhesive plate onto the cleaned surface.
4. Clean the metal plate you have put aside.
5. Remove the paper from the 3M adhesive plate and stick the metal plate onto it.
6. Screw the magnetic footing onto the DGPS receiver.
7. Place the DGPS receiver with the magnetic pedestal onto the metal plate.

Connecting the GPS receiver to a terminal

NOTICE
Terminal connector supplying power
Potential damage to the terminal from a short-circuit.
◦ Switch the terminal off before plugging in or removing the connector.
This is how you connect the DGPS receiver to a terminal:
1. Switch off the terminal.
2. Guide the cable of the GPS receiver into the vehicle cab.
3. Find the appropriate RS232 connection on the terminal. Refer to the operating
instructions for the terminal to find out which connection this is.
4. During initial start-up it can take approx. 30 minutes until the DGPS receiver has
reception. At subsequent start-ups it will only take approx. 1-2 minutes.
Mounting and configuration
Connecting the GPS receiver to a terminal
3
21