Sinbo SS 4036 Notice D'utilisation page 10

8. Cleaning and maintenance of the device
WARNING!
• Do not switch the device on if the roller unit has been removed.
• Do not use any astringent or abrasive cleaning agents.
• None of the parts may be cleaned under water.
After every application
• Clean the roller holder 2 and the roller 1/8 after every application.
1. Switch off the device.
2. Clean the roller holder and the rollers with the brush 10 after every application.
3. Place the protective lid 9 on the roller holder 2.
From time to time
• Wipe down the housing of the device with a damp cloth when necessary.
• Check whether the surface of the roller 1/8 is undamaged.
To do so, turn the roller and check the surface carefully.
9. Storage
DANGER!
Keep the device out of the reach of children.
NOTE: To prevent soiling, store the device with attached roller and protective lid.
• When the device is not being used, place the protective lid 9 on the roller holder 2.
• If you are not going to be using the device for a longer period of time, remove the batteries.
10. Replacing the roller
WARNING! Do not use the device if the surface of the roller is damaged.
When must the roller be replaced?
• When you can see signs of damage.
• If you need an increasing amount of time for the same result.
• Depending on the intensity of use, but generally after one year.
Removal
Press the button 6 and remove the roller holder upwards.
Attachment
1. Figure A: Place the roller holder 2 on the top of the device in such a way, that the cog wheels of the roller and
the device are above one another.
2. Press the roller holder 2 on to the device until it engages audibly.
3. Check that it is secure.
- 9 -