FAR SLEE7MI18W Manuel D'utilisation page 51

ENGLISH
Cleaning cabinet and inner tube
• Use soft damp cloth wipe when
cleaning cabinet and inner tube.
• Not to rinse by water direct
• Not to use neutral scour wipe.
• Not to use gasolene and alcohol wipe.
• Make sure open the front door for aeration
after cleaning die inner tube.
Safety reset
1. These dryers have a safety cut out switch
which is activated by temperature.
2. The safety reset button is on the backboard.
If your dryer not heating this button must
be reset before the dryer can heat again. You
may need to wait 10 minutes for cooling
down.
3. The most common reason for die dryer if
overheat is a blocked filter.
4. Clean file line filter after each load to prevent
overheating of the dryer.
The cut out switch may operate for the following
reasons:
1. Lint filter is blocked.
2. Exhaust outlets blocked at the back of the
dryer.
GB-20