Important - Enerpac FS-56 Manuel D'instructions

DANGER: Do not handle pressurized hoses. Escaping
oil under pressure can penetrate the skin, causing serious
injury. If oil is injected under the skin, see a doctor immediately.
WARNING: Only use hydraulic cylinders in a coupled
system. Never use a cylinder with unconnected couplers.
If the cylinder
components can fail catastrophically causing severe personal
injury.
WARNING: BE SURE SETUP IS STABLE BEFORE
LIFTING LOAD. Cylinders should be placed on a flat
surface that can support the load. Where applicable, use a
cylinder base for added stability. Do not weld or otherwise modify
the cylinder to attach a base or other support.
Avoid situations where loads are not directly centered on
the cylinder plunger.
Model
No. Pump Hose
FS-56 — —
FS-56S P-142
HC-9206Q
FS-109 — —
FS-109S P-392
HC-9206
Metal box included with FS-56, FS-56S, FS-109, FS-109S.
becomes extremely overloaded,
Off-center loads
Flange Spreader Selection Chart
Side
Cylinder Crossbar Plate
RC-53ST F56-2 (2) F56-3
RC-53ST F56-2 (2) F56-3
RC-102 F109-2 (2) F109-3
RC-102 F109-2 (2) F109-3
Cylinder
Lockpin (2)
considerable strain on cylinders and plungers. In addition, the
load may slip or fall, causing potentially dangerous results.
Distribute the load evenly across the entire saddle
surface. Always use a saddle to protect the plunger.
IMPORTANT: Hydraulic equipment must only be serviced
by a qualified hydraulic technician. For repair service,
contact the Authorized ENERPAC Service Center in your
area. To protect your warranty, use only ENERPAC oil.
WARNING: Immediately replace worn or damaged parts
by genuine ENERPAC parts. Standard grade parts will
break causing personal injury and property damage.
ENERPAC parts are designed to fit properly and withstand high
loads.
produce
Lock
Pin Pin
F56-4 (2) F109-8
F56-4 (2) F109-8
F109-4 (2) F109-8
F109-4 (2) F109-8
Adaptor Wedge
Pin
Figure 1
2
– 1 " 1
1/8 1/8 3/16
Adaptor Wedge
F56-5 F109-6 F109-7 (optional)
F56-5 F109-6 F109-7 (optional)
F109-5 F109-6 F109-7 (optional)
F109-5 F109-6 F109-7 (optional)
Crossbar
Side Plate (2)
– 2 " Wt.
3/16
Wedge Lb.
26
34
40
52