Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder to the machine,
introduce the shank and use the pin for
the positioning. Then tighten the 3 screws
of fixations (Important, make sure that the
screws have the same strength of
tightening).
1. Settle the offsets of 6 positions.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSE4307
2.
During the assembly or the dismantling
of your tools of cup, to block the brooch
on dishes planned for that purpose, by
using a key forks adapted.
3. The diameter of tail of a tool of cup
never has to have a difference
furthermore of 0.4mm with regard to the
diameter of the crowbar. Example: Ø of
crowbar 9.5mm - Ø tail 9.1 minimum.
MARK :
positions. Use the supplied corks.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 27.04.2021
never use the chuck with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
Mode d'emploi
GSE4307
Page : 2 de 4
Publicité
