Publicité
Les langues disponibles
Les langues disponibles
Connect to Battery:
With the 12 volt plug, plug the Male 12 volt plug into the Female 12 volt socket in the vehicle. Make sure
both ends are secure and are aligned correctly.
With Alligator Battery Clamps:
Connect the alligator clamps correctly by matching the red clamp which is positive (+) to the positive (+)
terminal on the battery. Connect the black clamp, which is Negative (-), to the Negative (-) terminal on the
battery. Follow this carefully to not cause any bodily harm.
Maintenance Instructions:
Cleaning of the glass may be performed by the userby utilizing a clean, damp cloth.
Any other maintenance to the unit should be performed by qualified service personnel or contact our
experienced customer service team.
Note:
This Solar Battery Trickle Charger has a built in blocking diode to prevent reverse discharge. The use of
this panel is not recommended while vehicle is in use. When operating your vehicle it is best to secure the
Solar Battery Trickle Charger in the glove box or under the seat.
FAQ
Can I use panel outdoors?
Yes, this panel has been weatherproofed. The weatherproofing includes UV protection and weather effects
of -35º F to 175 º F
Will my panel drain a battery at night?
No, this panel includes a blocking diode to prevent battery drain and reverse current.
What type of battery can a trickle charge?
Any 12 volt battery can be trickle charged with this solar panel.
How long will it take to charge a battery?
Under ideal conditions, this panel will generate up to 400 mAmps of current, supplying a steady trickle
charge to any 12 volt battery.
Do I need a charge controller?
A charge controller is not required for a 6 Watt solar panel. A 6 Watt panel will not overcharge your 12 Volt
battery. A charge controller is recommended for panels greater than 15 Watts.
Can I run appliances off this panel?
Yes, however, the current will vary depending on the sunlight. Charging a battery is therefore the
recommended installation and running protocol.
Can I mount this panel directly on a surface?
Yes, this panel can be mounted with the included stainless steel screws. To increase the heat dissipation,
a heat resistant spacer should be used between panel and surface for optimized use.
How far can I extend the wire?
Current length should accommodate 95% of installations; however, wires can be extended up to a
maximum of 30 feet with 16 gauge wires. Stripping wires to extend should be done carefully, connecting
positive to positive and negative to negative appropriately
TROUBLESHOOTING:
I am not sure if my panel is functioning?
- Ensure the battery is operational. Over time, a battery's ability to recharge will deteriorate.
Publicité
