Publicité
Les langues disponibles
Les langues disponibles
Installation (designed for
metal ductwork and plenum)
CAUTION: Plugging the 24V
Adapter into an outlet other
than 110V-120V volt labeled
voltage voids product
warranty and may do added
damage to the entire system.
1.
Once the mounting location is identified,
apply the yellow Installation Template
sticker to the surface and use template to locate position to cut hole as per Photo A.
2.
Using the metal hole saw provided, cut a 2 7/8" lamp hole as per Photo B with drill bit
provided.
3.
When installing on duct-board (as opposed to metal ductwork), use provided galvanized
duct-board Octagon Mounting Plate to provide stronger mounting surface. Position Octagon Mounting Plate with
duct-tape, no need to use screws. Apply supplied Installation Template on top of installed duct-board Octagon
Mounting Plate.
4.
Slide Mounting Ring into hole and affix with 3 Phillips screws (provided) as per Photo C.
5.
Remove LampClamp™ 'nut' from blue power supply. Insert UV Lamp into socket until it "clicks" in. Slide LampClamp™ over end of
UV Lamp and finger tighten.
6.
Carefully insert fixture with lamp installed into duct thru Mounting Ring as per Photo D.
7.
Line up holes of white connector cap to metal pins on Power Supply as per Photo E.
8.
Turn clock-wise until Power Supply is fully installed after which the system should appear as in Photo F.
9.
Slide yellow Locking Clip to lock Power Supply into Mounting Ring.
A
B
D
E
CAUTION:
Do not drill into refrigerant line or fan, etc.
C
F
CAUTION:
After cutting hole avoid sharp edges.
Connecting Power:
1
A 24V AC/DC Adapter is provided with your purchase. Plug adapter into 110V-120V wall socket and secure.
Connector Cap (White)
24V Power Supply Cap
(Blue)
Mounting Ring
UV-C Lamp Replacement Instructions:
To remove old UV Lamp:
1.
Unplug the 24V AC Adaptor from the wall power supply outlet.
2.
Disconnect the white power supply Connector Cap from the blue Power Supply Cap by turning counter-clockwise
3.
Slide the yellow locking clip outward and turn the blue Power Supply Cap counter- clockwise. Carefully pull out blue Power Supply
Cap & lamp assembly from the duct work through the Mounting Ring.
4.
Remove the Lamp Clamp Nut from the blue Power Supply Cap by turning the nut counter-clockwise. Remove the old UV Lamp.
To install the new UV Lamp:
1.
Insert the new UV Lamp 4-pins into the Lamp Socket. Slide the Lamp Clamp Nut from over the other end of the UV Lamp and finger
tighten.
2.
Carefully insert the blue Power Supply Cap with lamp into the duct thru Mounting Ring.
Turn clock-wise until blue Power Supply Cap is fully engaged. Slide yellow Locking Clip to lock blue Power Supply Cap onto
Mounting Ring.
3.
Line up holes of the white Connector Cap to metal pins on blue Power Supply Cap, turn clock-wise until it is fully engaged.
Plug the 24V power supply to the 110/120V wall power supply outlet.
NOTE: Do not remove the plastic sleeve on the lamp. This plastic sleeve protects the UV Lamp
from shattering in case of accident.
Used UV-C Lamp Disposal:
-
Visit
www.Earth911com
for your local or state waste management program and information about where to dispose the used UV-C
Lamp.
-
Contact your Local hardware stores, home improvement stores and other retailers who sell UV and
allow customers to drop off used bulbs for recycling.
-
If you cannot recycle, and if it is acceptable with your local agency, you may seal the bulb in a plastic bag and put in trash for
collection.
fluorescent
bulbs. Many stores
Publicité
