Pro Audio Trade bkl-wirelessdmxledtransmitter Manuel D'utilisation page 11

User manual
2.5 Set the Address
1. Hold 'SET' until dXXX blinks.
2. Choose the address by pressing '+' or '-', there are totally 512 addresses.
3. After choosing the address, hold the 'SET' until dXXX stops blinking.
2.6 LINK/ UNLINK
Link: Choose the zone for the DMX light bulb first by pressing '+' or '-', e.g. 'CH12' means zone 12. Turn off
the DMX light bulb, turn on again, within 3 seconds press SET three times, the light bulb blinks slowly
three times with green color, now the light bulb is linked in zone 12, there are totally 16 zones.
Unlink: Turn off the DMX light bulb, turn on again, within 3 seconds press SET five times, the light bulb
blinks quickly 10 times with red color, now the unlink is done.
2.7 How to Use
To adjust the first channel of any light under any zone (CHXX) or any address (dXXX), there are two steps
to follow, first choose this light bulb, then find out the red color channel, you can get it from the blow
formula
[dXXX + (CHXX-1) x5] / 16 = Q
1. When the result Q is not a whole number, and the reminder is E, then press Q+1 under Scanner and
choose this light bulb, then the red is the E channel, green is the E+1 channel, blue is the E+2 channel,
warm white is the E+3 channel, cool white is the E+4 channel.
2. When the result Q is a whole number, then press this number under Scanner and choose this light
bulb, then the red is the 16th channel, green is the 1st channel, blue channel is the 2nd channel,
warm white is the 3rd channel, cool white is the 4th channel.
Wireless DMX LED Transmitter
11