Maintenance And Troubleshooting - morse Metal Devil NXT CSM7NXTB Guide D'utilisation Et De Securite

MACHINE PREPARATION and OPERATION
CHIP COLLECTION AND REMOVAL CHAMBER
Metal chips may be very hot and sharp.
Wear eye protection whenever you open
the collection chamber.
Never touch metal refuse with bare hands.
Removal:
1 Loosen the two knob bolts holding the collection unit
to the saw (Fig. 14)
a. The chips accumulating can be seen in the
collection chamber window.
b. Chips should always be emptied when chamber is
approximately half full.
2 Tilt saw so collection unit is face down.
3 Pull collection unit away from saw. (Fig. 15)
4 Gently shake chips out of chamber into proper disposal bin.
NOTE: The knob bolts remain fastened to the collection chamber.
Re-Attaching:
1 Place the saw upright
2 Place collection unit on to saw and tighten knob bolts.

MAINTENANCE and TROUBLESHOOTING

• In case of electrical or mechanical malfunction,
immediately turn o the machine and disconnect the
plug. Ensure that the saw is unplugged and the blade
has stopped rotating before doing any maintenance.
• Keep your Metal Devil Circular Saw and cord clean.
Use only a damp cloth and very mild soap to clean the
saw.
• Excessive sparking can indicate the presence of dirt in
the motor or worn carbon brushes. Check for wear.
(Fig. 16A & 16B) Replace brushes when they reach 1/4"
(6mm).
• For all other service and maintenance take machine to
an authorized service center.
MACHINE LUBRICATION
This machine is lubricated during its manufacturing with
su cient lubricant to last approximately 72 hours of operation.
To add lubricant, it is necessary to dismantle the tool. This
procedure is best accomplished by an authorized service center.
TOOL OVERLOAD / RESET
If the tool overload protection device activates, allow the motor
to cool, (approximately 3 minutes) then press the reset button to
continue operation. (Fig. 17)
7
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE!
(Cont.)
(FIG. 14)
(FIG. 15)
(FIG. 16A)
(FIG. 16B)
(FIG. 17)