Page 1
ASSEMBLY & INSTALLATION INSTRUCTIONS INSTRUCCIONES DE MONTAJE E INSTALACIÓN INSTRUCTIONS D’ASSEMBLAGE ET D’INSTALLATION TETRIS Special composition QUALITY CONTROL / CONTROL DE CALIDAD / CONTROLE DE QUALITE Assembling inspection Inspección montaje Inspection du montage Packaging inspection Inspección embalaje Inspection de l’emballage NOTE: If you detect any anomality when receiving this product, please, retain thes document.
Page 2
INDEX ÍNDICE INDEX 1. INTRODUCTION 1. INTRODUCCIÓN 1. INTRODUCTION 2. RECOMMEND TOOLS 2. HERRAMIENTAS RECOMENDADAS 2. OUTILS RECOMMANDÉS 3. ROUGH-IN PREPARATION 3. PREPARACIÓN PARA LA INSTALACIÓN 3. PRÉPARATION À L’INSTALLATION 4. VANITY POSITION 4. POSICIONAMIENTO DEL MUEBLE 4. POSITION DE MEUBLE 5.
4. VANITY POSITION 4. POSICIONAMIENTO DEL MUEBLE 4. VANITY POSITION USA VERSION 1.804 5 ft 11” ” ” ” ” ” 1.736 5 ft 8 ” ” ” ” ” ” 1.200 ” Measures / medidas / dimensions: mm. / inches -It is recommended to use all screws.
Page 4
5. VANITY INSTALLATION 5. INSTALACIÓN DEL MUEBLE 5. INSTALLATION DE MEUBLES 1. Unpack pre-assembled unit carefully. Remove drawers 1. Desembale el mueble premontado cuidadosamente. 1. Déballez soigneusement les meubles préassemblés. / doors. With assistance, lift and place the vanity in posi- Retire los cajones / puertas.
Page 5
7. DRAWER REGULATION 7. REGULACIÓN DE CAJÓN 7. AJUSTEMENT DE TIROIR Drawers installation. Instalación de cajones. Installation des tiroirs. 1. Place the drawer on the extended slides. 2. Push the drawer fully home. Take apart the drawer. 1. Colocar el cajón sobre las guías extendidas. Drawer engages automatically!.
Los movimientos de frotar y secar deben rea- Pour le nettoyage journalier nous conseillons l’utilisation packaging. You can also get them from a Gamadecor lizarse en dirección de la veta para conservar la belleza d’une peau de chameau ou une éponge. Des produits distributor.
Page 7
-Joints/cut-outs/wall joints of all kind of worktops: para la limpieza de cristales de ventanas, etc. travail ou au distributeur Gamadecor. Worktop joints, wall joints and cut-outs on the surface for -Encimeras de aglomerado de cuarzo y cristal (tipo Si- sinks, etc. must be sealed during assembly so they are lestone) 3.
Page 8
9. WARRANTY. Bath furniture (V. 01/2015) 9. GARANTÍA. Mueble de baño (V. 01/2015) 9. GARANTIE. Meubles de bain (V. 01/2015) Scope of the Guarantee: Alcance de la Garantía: Étendue de la garantie: This Manufacturer’s Guarantee covers any claims for Esta Garantía del fabricante cubre cualquier posible re- La présente garantie du fabricant couvre toute récla- manufacturing defects affecting Gama-Decor brand clamación por defectos de fabricación de los muebles...
Page 9
GAMADECOR will not be responsible for any Warranty Conditions: In the event GAMADECOR recognizes that the affected...