Publicité
FCC Statements
Caution:
This device complies with part 15 of the FCC Rules / Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Le present appareil est conforme aux CNR d'Industrie Canada applicables ux appareils radio exempts
de licence. L'exploitation est autoisée aux deux conditions suivantes: (1 l'appareil ne doit pas produire
de brouilage, et (2) l'utilsateur de l'appareil doit accepter tout brouilage radioélectrique subi, meme si
le brouillage ext susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
The equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, mat
cause harmful interference to radio communications. However, there is no guarantee that interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try and connect the interference by one of more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Under industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (E.I.R.P.) is not more than that necessary for successful
communication.
Conformément a la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner
avac une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but réduire les risques de brouillage radioélectrique à l'intention des autres
utilsateurs, il faut choiser le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas nécessaire à l'éstablissement d'une communication satisfaisante.
MPE Remindding:
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and the persons during device operation. To ensure
compliance, operations at closer than this distance is not recommended.
Les antennes installés doivent être situées de facon à ce que la population ne puisse y être exposée
à une distance de moin de 20 cm. Installer les antennes de facon à ce que le personnel ne puisse
approcher à 20 cm oumoinsde la position centrale de l' antenne. La FCC des éltats-unis stipule
que cet appareil doit être en tout temps élongné d'au moins 20 cm des personnes pendant son
functionnement.
This product complies with the UL 60065 7th Rd. CAN/CSA 22.2 No. 60065_2003
Publicité
