Télécharger Imprimer la page
Rockwell Automation Allen-Bradley 140G-K Serie Instructions Pour L'installation
Rockwell Automation Allen-Bradley 140G-K Serie Instructions Pour L'installation

Rockwell Automation Allen-Bradley 140G-K Serie Instructions Pour L'installation

Publicité

Liens rapides

DIR 1000437R0002 Version 02 - 140G-K_; 140MG-K_
Installation instruction for 140G-K, 140MG-K
Istruzioni di installazione
Installationsanleitung
Instructions pour l'installation
Instrucciones de instalación
Installation - Installazione - Instalación
Instalação -
WARNING:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
Vor Installations- oder Servicearbeiten Stromversorgung zur
WARNUNG:
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT:
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
警告:感電事故防止のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。(NFPA70Eの要件に従ってください)
警告:为了防止触电,在安装或维修之前必须先切断电源。安装在合适的设备
箱内。防止接触污染 。符合NFPA70E要求)
3p
4p
DIR 1000437R0002 Version 02
-
Mounting hardware
End cap kit
CH 8
LENGTH
M
22 m m (0.87" ) M 1 0
140G-K-ECM3
140G-K-MH4
x6
140G-K-ECM4
140G-K-MH4
x8
Phase
barrier
LENGTH
M
85 mm (3.35") M 5
140G-K-PB3M
x4
x4
140G-K-PB4M
x4
x6
Bul. 140G/140MG
Insulator
Insulator
140G-K-BP3
x1
-
140G-K-BP4
-
x1

Publicité

loading

Sommaire des Matières pour Rockwell Automation Allen-Bradley 140G-K Serie

  • Page 1 Bul. 140G/140MG DIR 1000437R0002 Version 02 - 140G-K_; 140MG-K_ Installation instruction for 140G-K, 140MG-K Istruzioni di installazione Installationsanleitung Instructions pour l’installation Instrucciones de instalación Installation - Installazione - Instalación Instalação - WARNING: To prevent electrical shock, disconnect from power source before installing or servicing.
  • Page 2 Maximum recommended conductor support distance CLACK - Use cable or insulated busbars/ or perform specific type test on the installation. - Usare cavi o barre isolate/ o eseguire prove di tipo specifiche sull' installazione. - Kabel oder isolierte Sammelschienen verwenden / oder die spezifische Typprüfung auf der Installation durchführen.
  • Page 3 1.83 46.5 mm "/ 3.66 93 mm "/ 0.92 23.25 mm "/ OPTIONAL 61"/ 117 mm 4.53" 4.53" 2.54" 4.25" WITH ESCUTCHEON 115 mm 115 mm 64.5 mm 108 mm 4.21" 4.21" 2.38" 4.25" WITHOUT ESCUTCHEON 107 mm 107 mm 60.5 mm 108 mm DIR 1000437R0002 Version 02...
  • Page 4 THERMO-MAGNETIC TRIP UNIT CLACK - Manually trip the breaker prior to any adjustment of the magnetic trip settings. - E’obbligatorio mettere l'interruttore in posizione Trip test prima di regolare il termomagnetico. - Der Leistungsschalter muss vor Einstellung des thermomagnetischen Auslösers zwingend in die Prüfstellung geschaltet werden.
  • Page 5 ELECTRONIC TRIP TEST 140G-ELTT (ORDERED SEPARATELY) Push TEST button Premere pulsante TEST Drücken Sie die Test-Taste Appuyer sur le bouton TEST Pulse el pulsador TEST LED TRIP UNIT DEVICE - Red - Green - Rosso - Verde - Rot - Grün - Rouge - Vert - Rojo...
  • Page 6 Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies. Rockwell Automation maintains current product environmental compliance information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/ sustainability-ethics/product-environmental-compliance.page Publication 140G-IN021C-MU-P - June 2016 DIR 1000437R0002 Version 02 (L2233) - B0942 Copyright ©...

Ce manuel est également adapté pour:

Allen-bradley 140mg-k serieAllen-bradley 140g-k6f3-d40-muAllen-bradley 140g-k3f3-d30Allen-bradley 140mg-k8p-d30Allen-bradley 140g-k6f3-d40-ub-cjAllen-bradley 140g-k3h3-d30-aa ... Afficher tout