INTERTECHNO ITD-250 Mode D'emploi page 20

GB
The wireless mini flush-mount dimmer ITD-250 / ITD-251 can switch on/off all wire-
less lamps and can dim lights which use dimmable LEDs, dimmable energy saving
lamps, 230 Volt halogen lamps and 12 Volt halogen lamps with dimmable electronic
transformers up to 250 Watt.
Install in the supply line to dim or switch lamps on/off using the light switch (ITD-
250) or push button (ITD-251) as well as by remote control.
It's also easy to use in combination with a toggle switch. (Fig. 2b)
All teaching transmitters
and all transmitters for scene switching
from intertechno can be used.
Mounting (only to be carried out by a qualified electrician):
1.) Turn off the fuse.
2.) The connections must be configured as shown in figures 2a and 2b (for toggle
switches).
Encoding (Fig. 3)
3.) Turn on the fuse again.
The LED will shine for 10 seconds, this means it is ready for operation.
4.) Briefly press the learn button (L) on the module with a pointy object (e.g. paper
clip, ballpoint pen).
The LED will flash.
5.) Press the ON button on the transmitter.
The LED will flash 3x as confirmation.
The encoding is now complete.
If no signal is transmitted within 12 seconds, the learning process is automatical-
ly aborted.
A total of 32 different codes or teaching transmitters (no letter and number encod-
ing) can be taught in.
The first code will be deleted if more codes are entered.
The encoding remains saved even after a power cut.
Using several wireless receivers opens up many switching options such as individual
and group switching.
The Wireless Mini Flush-Mount Dimmer ITD-250/ ITD-251 also has a storage function
for scene switching.
Refer to the respective transmitter's instruction manual (e.g. ITF-100, ITKL-30) for
details on scene switching.
Several different wireless receivers can be set to the selected switching state at the
push of a button.
e.g: Ceiling light OFF/Fan ON/Floor lamp DIMMED
Operating instructions
3
ITD-250/251
›