Brandson Equipment 304764 Mode D'emploi page 10

5. Assembly
Make sure that cables, lines or water pipes are not damaged during mounting.
Ideally, identify the mounting location before starting to drill.
First, choose a mounting location that can bear the weight adequately. Make sure
that the entire pivoting range of 180° can be utilised. Make sure that the distance
to the tap is selected so that the connection hose has slack when it is connected.
Constant tension on the connection hose may damage the device!
Provide a minimum distance of 50cm on each side for positioning the hose reel.
Note that there must be a minimum distance of 1.5 m on one side.
Caution! Mark the holes before drilling! Make sure that you drill carefully and at
the right place!
Mounting on wood
• Mount the wall bracket vertically using two wood screws.
Mounting on concrete or stone
• Drill two holes using an appropriate drill.
• Insert two dowels into the previously drilled holes.
• Then mount the wall bracket vertically using two screws.
6. Cleaning, care and storage
• Clean the surface of the product with a soft, slightly moist cloth. Never use
chemical or aggressive cleaning agents.
• Disconnect the water hose from the tap and allow the remaining water to drain
out completely.
• Allow the entire hose reel to dry completely.
• Keep the product in a clean and dry place.
• Never open the product. Opening the product results in loss of warranty.
10
English