Warn 90459 Instructions De Montage page 5

INSTALLATION CONT.
4. Mount the winch assembly to the front bum-
per, as shown in Figure 4, using four M12
x 1.75 x 25mm flangehead capscrews and
flange nuts provided in the hardware kit. Use
a 16mm wrench and 18mm socket to loosely
secure in place at this time. Remount the
bumper to vehicle in reverse procedure using
hardware previously removed and tighten
hardware hand tight at this time.
5. Tighten and torque all hardware in place,
according to torque specification on page 2.
As shown in Figure 6, fairlead mounting tabs
are visible on front of bumper. Route winch
cable through bumper and fairlead. Install
fairlead using two M10 x 1.25 x 20mm flange
head capscrews and hex nuts. A 14mm
socket and 17mm wrench can be used to
tighten in place. Torque to 30 lb. ft. (40.7
N-m). Finally, install hook and strap.
6. Using original tox drive hardware, you may
modify middle grill plate and re-install or
leave it off if you prefer. Figure 6 shows final
installation.
PAGE 5
Figure 4
Figure 5
Figure 6
90486A0