Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. ReMoVe olD CoVeR AnD ReAsseMBle CoVeR RAIls
A. Place the cover rail
at each leg and secure it at each leg with a cover clamp as shown below.
(10110)
B. Slide the cover rails so they are 8 inches up from the ground and hand tighten bolts on clamps.
Middle Rib Cross Rail Clamps
10273
10111
10115
ReAR
10110
10110
01010
01010
10110
End Rib Cross Rail Clamps
10110
10112
10110
10115
10110
10110
10110
FRonT
01010
10226
2. sqUARInG Up THe FRAMe
A. Place frame in its final location, which needs to be as flat and level as possible.
B. Measure across opposite corners. These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame measures 12 feet in width
12'
12'
Page 4
05-211113-0A
Publicité
Table des Matières
