Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 1 middle part
- 3 plastic spacers Ø10 L : 10mm
- 4 BHc 5×15 screws (small head)
- 4 M5 Nylock nuts
- 2 pieces of aluminium netting 27×7 cm
Assembly
- Remove the original belly pan. Keep the oval original « silent block » which maintains the original belly pan
to the exhaust cover.
- Thanks to the BHc 5×15 screws, plastic washers Ø5 and M5 Nylock nuts, assemble the 3 parts of the belly pan
(the middle part shall be placed inside the other 2 parts).
- Place the « silent block » on the belly pan (the flange of the spacer shall be outside of the belly pan). Replace
the oval original « silent block » on the belly pan.
- Place and fit the belly pan on the motorbike thanks to the BHc 6×40 screws, by inserting the spacers between
the belly pan and the motorbike (the spacer L : 15mm is placed on the lower left fixation of the belly pan).
- Aluminium railings are one option. They take place at the air intakes with stick for windshield (polyurethane
stick).
- From Z1000 2014 :
Once fitted, the belly pan must have no contact with motor and has to be far
enough from complet exhaust system. Fitting brackets' angles may be a little
modified in order to adjust the accessory to every motorbike (do not fold the
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Harden the rear shock absorber while drivings with passenger or load.
fixing brackets while fitted on belly pan).
ADAPTABLE ON Z 1000 2010 → ∞
- 4 « silent block » with steel spacers
- 1 plastic spacer Ø10 L : 15mm
- 4 plastic washers Ø5
- 4 BHc 6×40 screws (small head)
« CAUTION »
FITTING INSTRUCTIONS
ERMAX BELLY PAN
Ideally :
wing to drill Ø5 and thread M6
Rescue solution :
drill Ø6 and put screw and nut
Publicité
