Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch
to the following equipment:
• ESAB 750I, 875I and 1000i
Parts Supplied
The following parts are included in this kit:
• Control Connector Plug with Connectors - 1 ea
• Adapter Fitting - 1 ea
• Ring Terminal - 1 ea
• Protective Boot - 1 ea
Installation
Install the Adapter Kit per the following procedure:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. Slide the Protective Boot, included in this kit, over the end of the Negative / Plasma Lead.
5. Place the Adapter Fitting provided into the Power Supply torch power cable fitting (-) and tighten securely.
6. Connect the pilot wire (+) from the replacement torch to the Power Supply and tighten securely. If required, use
the ring terminal provided.
© 1998 Thermal Dynamics Corp., Printed in USA
Date: September/Septembre 6, 2002
Control Connector
Plug with Connectors
Torch Control
Connectors
Pilot Lead
Negative/Plasma Lead
Torch Lead Assembly
Adapter Fitting
A-02217
1
Manual 0-2715
RPT Adapter Kit
Catalog # 7-3429
Installation Instructions
Manual/Manuel 0-2715
Publicité
Sommaire des Matières pour Thermadyne THERMAL DYNAMICS 7-3429
- Page 1 Manual 0-2715 RPT Adapter Kit Catalog # 7-3429 82 Benning Street, West Lebanon, NH 03784 USA (603) 298-5711 • www.thermal-dynamics.com Installation Instructions General Information This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch to the following equipment: •...
- Page 2 7. Connect the Negative / Plasma Lead from the replace- ment torch to the Power Supply. Slide the protective boot over the lead connection. NOTE 8. Connect the Control Connector Plug, with two connec- For Mechanized Systems refer to the Torch Control tors, to the two mating connectors on the replacement Cable Wiring Diagrams in the Manual supplied with torch leads, see NOTE.
- Page 3 Manuel 0-2715 Kit D’Adapteur De RPT Catalogue # 7-3429 82 Benning Street, West Lebanon, NH 03784 USA (603) 298-5711 • www.thermal-dynamics.com Instructions D’Installation Informations Générales Ce kit d’adapteur de torche de rechange doit être employé pour connecter la torche de découpage de série du plasma RPT de Thermal Dynamics à...
- Page 4 6. Connectez le fil pilote (+) de la torche de rechange à l’alimentation d’énergie et serrez solidement. S’il y a lieu, utilisation la borne d’anneau fournie. 7. Connectez le fil de Négatif/Plasma de la torche de rechange à l’alimentation d’énergie. Glissière l’amorçage protecteur au-dessus du raccordement de NOTE fil.