Modes Of Use - TEUFELBERGER treeMOTION evo Mode D'emploi

Use
used on one rope bridge each. This
allows for easier change from one
anchor point to another and the two
rope bridges may be adjusted to
different lengths. A second ring may
be purchased at Teufelberger. (see
chapter on replacement parts) Note:
Both rope bridges must be mounted
on the harness, even if only one is
used.
The climber shall fully equip the har-
ness for the task to be performed, then
hang in suspension and adopt a range
of work positions to ensure that the
harness is properly fitted, comfortable
and suitable for the task. Leg and back
paddings are attached to the harness
by hook-and-loop fastener and can be
removed for cleaning and put back in
place.
2.5. ADJUSTMENT OF BUCKLES
The Cobra FX25 buckles of tree-
MOTION evo are equipped with an
elastic cover that is easy to push
back. It is there to protect the buck-
le from dirt. Always push the cover
10
back sufficiently to check that the
buckle is securely closed. Listen for
two "click"-noises! Then put the cover
back in place. For information on how
to clean the buckle go to chapter 7.

3. MODES OF USE

There must not be any chance of a
free fall. „Free fall" does, however, not
mean e.g. slipping of the user´s feet.
Choose the connection of the harness
to an anchorage point at a level which
will result in the least total fall distance
consistent with the user's ability to
carry out work tasks.
When making any connection to a point
on a harness which cannot be seen by
the wearer of the harness, either make
it before putting the harness on or have
pic. 7
it made or checked for security by a
second person.
Use as Work Positioning Belt on the
basis of EN 358
Lateral loading of the harness:
Feet should be well supported (e.g.
pic. 8
standing on pole with spikes). Work
positioning lanyard on a level with
waistline when connected to both
standing rings (4). (pic. 9)
The centre rear ring (pic. 10) is NO
pic. 9 pic. 10