Technical Specifications; Important - ELTRA Select Plus Mode D'emploi

Art. : 010200270

IMPORTANT

• Read this manual carefully.
• Keep the time switch out of the reach of children.
• This switch is for indoor use only.
• Always unplug the switch from the power outlet when you are cleaning it.
• Always clean it with a dry cloth.
• Do not use detergent or other chemicals when cleaning.
PROGRAMMING
SETTING THE TIME

TECHNICAL SPECIFICATIONS

• Operating Voltage: 230V (50Hz)
• Maximum resistive power: 3500W/16A
• Maximum inductive power: 460VA/2A
• Day programming: periods of 30 minutes.
• With selector
• Resistive devices are devices that use the same
amount of power throughout the entire duration. E.g.
lamps.
• In contrast, inductive devices consume more power at
start-up than during normal operation. This includes
washing machines, dryers, water heaters, heaters, etc.
• If the inductive device exceeds the value of the
inductive capacity of the time switch, the
device may not be connected to it; failure to do so
could cause the switching contact of the timer to
prematurely break down, and this falls outside the
warranty.
The switching on and off times are simply programmed by
carefully pulling up the segments on the rotary dial at the time
the connected device must switch off. The device will start to
operate at the times the segments are left inward.
So, if you want to switch the power on from 5:00 PM to 10:00
PM, slide ALL tappets between the number 17 and 22 inwards.
• Rotate the ring clockwise until the correct hour is opposite
the arrow.
• Then, plug the time switch immediately into the power
outlet.
• Repeat this procedure every time after the timer switch
was removed from the socket.
UK