WarmlyYours TW-ST-06PS-PL-HD Manuel D'installation

TOOLS REQUIRED
+
ACCESSORIES
1. & 2.
4.
3. 5.
(1) + (2) Round Wall hang bracket + set screw
(3) 3pc Bushings and 1pc short tube for wall bracket
(4) Long screw
(5) Plastic wall anchor
(6) Short screw
(7) Hex Key Wrench
INSTALLATION
1
As shown in the picture, push the short
screw (6) through the hole in the sheet
metal of the bracket (1)
2
Use the short screw (6) to attach the bracket
onto the metal pad located on the rear of the
vertical tube.
6.
7.
Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
STUDIO TOWEL WARMER INSTALLATION MANUAL
3
Tighten the short screw (6) with a screwdriver. Note that
the hole of the bracket (1) should face downward towards
the floor when the towel rail is mounted to the wall.
4
Attach the three remaining brackets (1) to the vertical tubes
by repeating steps 1 through 3.
5
Use a tape measure to measure the distance between
these four mounting holes. Use the tape measure to get
the distances of A-B, A-C, C-D, B-D, A-D, and B-C.
6
Use a pencil to mark locations A, B, C, D on the wall
A B
according the measurements. We suggest mounting the
Towel Warmer at least 24" (600mm) above the floor. We
C D
suggest mounting the left rail of the towel warmer to a
stud, if possible.
600mm
7
Use a drill with an appropriately sized drill bit to make the
holes for A, B, C, and D. If mounting to a stud, only drill
holes B & D.
ITEM# TW-ST-06PS-PL-HD
PAGE 1