General Information - Mr. Heater MH12HB Instructions De Fonctionnement

GENERAL INFORMATION:

•
When the heater is cold, it will take a few minutes for
the burner tile to turn bright orange. This is normal and
the heater is working properly. If burner tile is visibly
flaming, turn heater off and call a qualified service tech-
nician.
Note: The heater is to be used outdoors, but may experi-
ence nuisance shutoffs due to certain wind conditions.
•
When the unit is lit, there should be about a quarter
inch border around the tile that will not turn bright
orange. This is normal.
•
When operating the heater for the first time, the top
area of the reflector may discolor. This is also normal
and is no reason for concern.
• The protective grill on the front of this heater is coated
with a special high-temperature resistant paint. When
the heater is used for the first time, the grill may give
off noticeable smoke or fumes. This is normal and will
not occur during subsequent uses. The fumes are not
harmful.
•
Designed to operate at altitudes up to 7,000 feet.
When operating the heater at altitudes over 7,000 FT.
above sea level, the unit may not burn as bright as
in lower altitudes. This is normal. At higher altitudes,
the heater may shut off. If this happens, provide
fresh air, wait 5 minutes and re‑light. If the heater
continues to shut off, there may not be enough oxy‑
gen available to feed proper combustion.
•
Operating time will vary depending on the heater
setting and the supply cylinder size. Up to 1.5 to 3.5
hours on a 1 lb. cylinder. Up to 36 to 72 hours on a 20
lb. cylinder (based on "HI" and "LO" settings). Due to
the properties of LP gas, run times can be significantly
reduced when operating continuously at temperatures
below 20º F. Use of a 20lb tank is recommended in
these conditions.
•
When moving heater when lit or bumping heater setting
it down, the tip over switch may shut off heater. If this
happens, re-light.
•
Do not leave this appliance unattended while it is in
operation.
•
LP cylinders must be marked in accordance with
"Cylinders, Spheres and Tubes for Transporation of
Dangerous Goods, CAN/CSA B339".
LIGHTING / OPERATING
INSTRUCTIONS FOR USE WITH
DISPOSABLE 1 LB. PROPANE
CYLINDERS:
WARNING: Always inspect propane cylinder and heater propane
connections for damage, dirt, and debris before attaching
propane cylinder. Do not use if head of cylinder is damaged,
punctured or deteriorated.
ALWAYS ATTACH OR DETACH CYLINDER OUTDOORS AWAY
FROM FLAMES, OTHER IGNITION SOURCES, AND ONLY WHEN
Mr. Heater | Portable Propane Heater
HEATER IS COOL TO
TOUCH. NEVER SMOKE
WHEN ATTACHING OR
REMOVING PROPANE
CYLINDER OR MAKING
REMOTE CONNECTIONS!
•
Use only LP-gas
cylinders marked in
accordance with the
U.S. Dept. of Trans-
portation (DOT).
•
Use only 16.4 oz.
(1 lb.) disposable
cylinders that mate
with No. 600 valve
connection.
•
Heater and attached
cylinder must be in
an upright position
during operation.
•
Make sure four-po-
sition Control Knob
is in "OFF" position;
see Figure 1.
• Open the right side
door, swivel regula-
tor outward for easy
tank installation.
Screw 1 lb. dispos-
able LP-gas supply
cylinder clockwise
(from bottom) into
portable heater until
hand-tight; see Fig-
ure 2. DO NOT use
thread sealant on
this connection.
•
Check cylinder con-
nection for leaks
with soapy water at
the threaded con-
nection under the
domed plastic cover
where the cylinder
screws into the regu-
lator. SEE
WARNING! ON PLAS-
TIC ADDESS Door.
Close access door.
•
Turn Control Knob
counterclockwise to
"PILOT" position and
depress the pulse ig-
nition button located
in the accessory com-
partment (see pg 7).
4
Operating Instructions and Owner's Manual
HI
LO
PILOT
OFF
Figure 1: "Off" position.
Figure 2: Attach fuel tank
Figure 3: Ignition
Figure 4: Release knob.