Material Specifications - CAMP NAVY XTRA Mode D'emploi

curs, remove the support immediately. Check your
skin on a daily basis. Do not leave the back panel in a
warm car or near a warm radiator as this may alter the
shape. Do not use the brace in chlorinated water.

Material Specifications

The product is made from Nylon, Spandex, Polyester.
The plastic back section is made from low temperature
thermoplastic 3D-LITE. The cover is made from
Polyamide and Lycra. This product does not
contain Latex. This product is not flame retardant.
Washing Instruction
Remove the plastic inserts from the front panels and
the plastic back section from the pocket. Remove the
strip of hook that is used to attach the pocket to the
USER INSTRUCTIONS
Check that the product is complete and without damage.
back support. Do not put any of the these parts
into the washing machine. The remaining section
of back support can be machine washed at a warm
temperature (40 C). Dry flat. Do not dry-clean,
o
bleach, tumble dry, or iron. The plastic sections can
be cleaned with a mild soap and towel.
Who to Contact
If any problems occur, remove the support and
contact your clinician or store where purchased.
Use an undergarment (t-shirt / body stockinette) under the
back brace for added comfort. Wash both undergarment
and brace on a regular basis.
Loosen the xtra elastic straps. Grasp the front panels,
centre back rigid panel along your spine and slide up
or down until it rests comfortably in the lower back
area.
Pull front panels over the lower abdomen, right and
left, then secure. Grasp the outer elastic straps, pull
forward, snug the rigid back in position against the
spine. Press the hook end into the plush fabric in
front. Make sure your abdomen is firmly compressed
to 'lift' the abdomen.
For best results make sure the brace is on your lower
back and is pulled snug for comfort.