Dimensions; Controls, Indicators And Connections; Inspections Prior To Starting; Starting Up - Diamatic BDC3140 DBP Manuel D'instructions

The choice of professionals

Dimensions

Model
A (mm)
B (mm)
C (mm)
Weight (kg)
Model
A (mm)
B (mm)
C (mm)
Weight (kg)
■ Storage conditions:
Temperature: -10°C ÷ +40°C
Humidity: ≤ 85%
■ Operating conditions:
Maximum altitude: 800 m
(Up to 2,000 m with reduced performances)
Temperature: -10°C ÷ +40°C
Humidity: ≤ 85%

Controls, indicators and connections

1. Dust container release lever
Castor lever
2.
3. Main switch
4. Start button
Stop button
5.
6. Voltage presence white indicator
7. Thermal protection operation red indicator
Pressure governor
8.
www.diamaticusa.com
info@diamaticusa.com
Figure 3
3140 DBP
230/60 440/60
1600
1200
600
212 212
3140 LPP
230/60 440/60
1600
1200
600
216 216
[ NOTE ]
Figure 4

Inspections prior to starting

Figure 5
Inlet
1.
Prior to starting, check that:
The filter is installed.
■
■ All latches are tightly locked;
The vacuum hose and tools have been correctly fitted
■
into the inlet (1);
■ The bag or safety container is installed, if applicable.
Do not use the device if the filter is faulty.

Starting up

Figure 6
1. Castor brakes
Lock the castor brakes before starting the vacuum cleaner (1).

Starting/stopping the vacuum cleaner

Turn the switch (3) (figure 4) to "I" position to
■
electrically power the vacuum cleaner. The voltage
presence indicator (6) (figure 4) comes on.
Push the start button (4) (figure 4) to start the vacuum
■
cleaner.
■ Push the stop button (5) (figure 4) to stop the vacuum
cleaner.
Turn the switch (3) (figure 4) to "0" position to turn off
■
the electrical power of the vacuum cleaner.
WARNING!
Check the pressure of the air used to clean the
filters which is produced by the compressor.
It must never be superior than 5.5 bars, if
necessary, adjust it to the correct level using the
related pressure governors (9 e 11) (figure 4).
WARNING!
The activation of the indicator (7) (figure 4) signals
the operation of the vacuum unit thermal protection
due to the excessive electrical power draw of the
unit.
US
7/12