Oxygenated Fuels; Starting The Product; Stopping The Product - Toro 51948 Manuel De L'opérateur

Oxygenated Fuels

NOTICE:
Do not use E15, E20, or E85 fuel (or fuel
containing greater than 10% ethanol) in this
product. It is a violation of federal law and
will damage the unit and void your warranty.
Fuel system damage or performance problems resulting
from the use of an oxygenated fuel containing more than
the percentage of oxygenates stated below are not covered
under warranty.
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) is acceptable. E15, E20, and
E85 are not.

Starting the Product

See Figures 4 - 5.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air filter cover.
To Start a Cold Engine:
Follow these steps to start a cold engine.
1. Lay the product on a flat, bare surface.
2. Push the primer bulb approximately eight times.
FULL CHOKE
3. Set the choke lever to
4. Depress trigger lock-out and squeeze throttle trigger fully
(thru step 7) and pull starter handle sharply until engine
attempts to start (no more than 4x).
HALF CHOKE
5. Set the choke lever to
6. Pull starter handle until engine runs, no more than 6
pulls.
RUN
7. Set the choke lever to
Note: In cooler environments, additional pulls of the
starter handle may be required with the choke lever in
FULL CHOKE
the position.
On/Stop
Lock-out
Switch
Switch
Throttle
Primer
Trigger
Bulb
Operation
.
.
.
Starter
Grip and
Rope
Figure 4
Set Choke to FULL
To Start a Warm Engine:
Follow these steps to start a warm engine.
1. Lay the product on a flat, bare surface.
2. Push the primer bulb up to eight times.
RUN
3. Set the choke lever to
4. Depress trigger lock-out and squeeze throttle trigger
fully, pull the starter cord.
Note: If the product does not start, repeat the previous
steps.

Stopping the Product

See Figure 6.
Follow these steps to stop the product.
1. Release the trigger.
2. Press and hold on/stop switch to (STOP) position until
the engine stops. The switch will automatically return to
the (ON) position when released.
Throttle
Trigger
Set Choke to RUN
Figure 5
.
On/Stop
Switch
Figure 6
13