Accessories List - Digitus DN-95639 Guide D'installation Rapide

Accessories list

1. One serial cable
2. One network cable (only intelligent ATS)
3. Four Ø 6 x 16 mm cross bolt
4. One user manual and CD
5. Optional accessories
5.1. Circuit breaker (either circuit breaker or surge protection)
5.2. Surge protection module (either surge protection or circuit breaker)
Mounting Method
Horizontal rack mounting
Hardware Introduction
1. Self-checking when power on
The buzz beep once when power on, the LED indicator always lights on, digital screen
display load current after self-checking.
2. Operation status viewing
Through "press to select date" button, user can view the voltage; IP address (only
intelligent type) and device version number.
3. Select the preferred power source.
Use Preferred button to select the primary power source, three options users can
have: set the source A as the preferred power source; set the source B as the
preferred power source; or user can leave this open. The corresponding indicator will
always light on if a choice was made. If not, the two indicators will stay the off status.
Please be noted that the intelligent ATS is with the Lock function, if user cannot do
the setting above, please log on to the Web web interface to unlock.
4. Reset operation.
If want to manual-reset ATS, Press the Reset button to reset the rack PDU without
affecting the outlet status.
5. Restore to factory settings
Press and hold the "press to select data" button for 6 seconds, the LED screen will
display "IP" when release, then press the Reset to restore to the default IP
192.168.1.163 and default Username and password.
6. Serial connection
Use the supplied serial cable, insert the RJ45 connector to RS232 communication
port and connect the other end to the serial port of local PC.
4