Charging Procedure - Poulan Pro PPB402AH Manuel D'instructions

solution in the eyes or on skin, and do not
swallow it.
• DO NOT place these batteries in your
regular household trash.
• DO NOT incinerate.
• DO NOT place them where they will
municipal solid waste stream.
•
disposal center.
40V Li-ion Battery Charger: PPB40CGR
Input: 100-240V AC 50/60HZ 2A
Output: 40V DC 2.2A
Class 2 Battery Charger
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger
(2).
2
3. This is a diagnostic charger. The Charger
order to communicate the current battery
status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM OR TOO COLD:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
OPERATING INSTRUCTIONS
CHARGER SPECIFICATIONS

CHARGING PROCEDURE

1
3
RED
RED
GREEN
RED
RED
ORANGE
OFF
RED
RED
RED
BLINKING
•
repair person using only identical
replacement parts. This will ensure that
the safety of the product is maintained.
• Risk of Fire and Burns. Do Not Open,
Crush, Heat Above 100°C (212°F) or
Incinerate.
CAUTION:
FOR INDOOR USE ONLY
CHARGE ONLY RECHARGEABLE
BATTERY PACK PPB402AH / PPB404AH,
OTHER TYPES OF BATTERIES MAY
BURST CAUSING PERSONAL INJURY AND
DAMAGE.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING:
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules.
4
Changes or