Charging Procedure; Charger Maintenance; Battery Pack - Poulan Pro PPB40PS Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CHARGING PROCEDURE

NOTE: The battery is not shipped fully
charged. It is recommended to fully charge
before first use to ensure that maximum
run time can be achieved. This lithium-ion
battery will not develop a memory and may be
charged at any time.
1.
Plug the charger into an AC power
outlet.
2.
Insert the battery pack (1) into the
charger (2). This is a diagnostic
charger. The Charger LED Lights
(3) will illuminate in specific order to
communicate the current battery status.
They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
2
CHECKING BATTERY CAPACITY
Press the Battery Capacity Indicator (BCI)
button. The lights will illuminate according to
the battery's current power level. See chart
below:
BATTERY CAPACITY
INDICATOR (BCI)
BUTTON
Lights
Capacity
4 Green Lights
The battery is at full capacity
3 Green Lights
The battery is at 70% capacity
2 Green Lights
The battery is at 45% capacity
1 Green Light
The battery is at 10% capacity
and requires charging soon
Lights go out
The battery is under 10%
capacity and requires charging
immediately.
MAINTENANCE
RED
RED
RED
GREEN
ORANGE
RED
OFF
RED
RED
RED
BLINKING
1
3
LIGHT METER
BATTERY METER

CHARGER MAINTENANCE

Keep the charger clean and clear of debris.
Do not allow foreign material to get into the
recessed cavity or onto the contacts. Wipe
the charger clean with a dry cloth. Do not
use solvents or water, and do not place the
charger in wet conditions.
Unplug the charger when there is no
battery pack in it.
Fully charge the batteries before placing
them in storage.
Store the charger at normal room
temperature. Do not store it in excessive
heat. Do not use the charger in direct
sunlight. Recharge at room temperature
between 45˚F and 104˚F (7˚C and 40˚C).
If the battery pack is hot, allow it to cool
down inside of the charger. The battery
will begin charging once it has returned to
room temperature.

BATTERY PACK

Store the battery pack fully charged.
Once the charging light turns green,
remove the battery from the charger and
disconnect the charger from the outlet.
Recharge the battery pack anytime you
notice there is less power. Never let
the battery pack become completely
discharged.
After charging, the battery pack may
be stored in the charger as long as the
charger is not plugged in.
18

Publicité

Table des Matières
loading

Table des Matières