Publicité
Les langues disponibles
Les langues disponibles
Keeping screw of the taillight and the screen holder
Fitting kit
- 1 carbon look support
- 4 BHc 5x20 screws
- 4 cm rubber seal
Assembly
- Remove the outline of meters. Unscrew the 2 screws that hold on the taillight.
- Place the pieces of rubber seal and the inserts on the carbon look holder.
- Fit the support on the motorbike thanks to the the original screws.
- Replace the outline of meters and fit the screen on its holder with the Ø5 screws and washers.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
Position of pieces of rubber seal
- 4 M5 rubber inserts
- 4 Ø5 plastic washers
« CAUTION »
« NOSE SCREEN »
YAMAHA XJ-6 2009 → ∞
Publicité
