Publicité
Les langues disponibles
Les langues disponibles
Rear right bracket
Rear left bracket
Assembly
- Fix the bracket as indicated on photo without completely tightening the screws.
- Assemble the belly pan using all Ø 5 nuts and bolts supplied.
- Place the belly pan, centre it and ensure it's clear of the exhaust pipes or oil and clutch sumps. Then
position the brackets in front of the belly pan holes.
- Tighten brackets (1,2 nm/kg) and fix the belly pan with the Ø6 screws and washers provided.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical
data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal
road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Fitting kit
- 4 brackets
- 4 6×15 BHc screws
- 4 plastic washers Ø6
- 3 5×15 BHc screws
- 3 plastic washers Ø5
- 3 Ø5 nylstop nuts
"ATTENTION
FITTING INSTRUCTIONS
« BELLY PAN »
SV 650 / DL 650 2003 → ∞
Front right bracket
Front left bracket
Publicité
