Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 plastic collars (1 long 350 mm, 1 short 200 mm)
- 1 self adhesive pad
- 1 Ø5L5 rubber spacer
- 1 6x20 BHc screw
Assembly
- Remove the chain guard and the rear brake hose bracket.
- Place the hugger using the original screws without blocking the tightening. The provided spacer
and screw are going on the hose bracket side. Check the hugger centring and block screws.
- Put the long plastic collar on the right front side of the hugger and press it to the swinging arm.
- Stick the self adhesive pad on the rear hugger, then fix the rear brake hose with the short plastic
collar.
* The "Ermax" mudguard and undertray are compatible.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the
technical data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Self-adhesive pad and short collar
« CAUTION »
FITTING INSTRUCTIONS
« REAR HUGGER»
Z 750 S 2005/2006
Z 750 N 2007 → ∞
Original tyre Bridgestone BT 012 in 180/55 ZR 17.
Dunlop SportmaxQualifier 180/55 ZR 17
Estimated assembly time: 15 mn
Long collar
Publicité
