Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 1 M8 nut
- 3 BHC 6×10 screws
- 1 BTR 8×120 screw
- 3 rubber washers
- 3 M6 nuts
- 3 fixing brackets
Assembly
- Attach the front brackets using the BTR 8×120 screw and the M8 nut on the lower engine hole
situated next to the hole filter (see photo).
- Fix the rear bracket to the exhaust/frame fitting point (see photo).
- Do not tighten up completely at this stage so as to allow adjustment at the fixing points later.
-Position the belly pan and attach it at the three fitting points, using the three BHC screws, the
three M6 nuts and the three rubber washers. Move the belly pan backwards and/or forwards as
required to ensure that it is well clear of the exhaust pipes.
- Tighten up the bracket screws, along with the three belly pan screws.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical
data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal
road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
SV 650 1999/2002
ATTENTION
« BELLY PAN »
Publicité
