Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 fixing brackets
- 4 6×15 screws
- 4 6×13×1 steel washers
- 4 M6 nuts
- 4 Ø6 mm rubber washers
Assembly
- Position the four fixing brackets without tightening completely to be able to move them later as
shown on the photos.
- Place the belly pan and put the Ø6 screws with the rubber washers (to protect the paintwork) and
the steel washers with the Ø6 nuts on the fixing brackets without tightening completely.
- Be careful to position the belly pan properly to ensure that it is well clear of the exhaust pipe and
high enough to clear the floor. Adjustment can be achieved by moving the bracket. Then tighten the
brackets and screws completely.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
FZS 600 FAZER 1998/2003
« CAUTION »
"BELLY PAN"
Publicité
