Adjusting The Transmitter Station Number - Toro EZ-Remote Guide D'utilisation

To pause station operation:
• Press the
PAUSE
pause. If pause is not manually released, the station will remain paused for 10 minutes, then shut off.
To turn off the station operation:
• Press the button.
OFF
To advance through the station sequence:
• Press the
NEXT
Each time the
NEXT
ous station will shut off. Continuing to advance past the last station will automatically start the first
station again.
Adjusting the Transmitter Maximum Station Number
The transmitter is preset to operate 12 controller stations. The maximum station number is adjustable
from 1 to 64 stations. For best results, the station number in the transmitter should be set to match
the number of controller stations being used. For example, if the controller has eight stations or is
only using eight stations out of a possible 12, the transmitter should be reset to eight as follows:
• Simultaneously press the
• Adjust the maximum station number by pressing (or pressing and holding) either the
ton until the desired number is displayed, then immediately release the button. When the number
is correctly displayed, simultaneously press the
• To check the new maximum station number, press the
should return to 1 after passing the new maximum station number .
button once to pause station operation; press the button again to release the
button. The first station number displayed will automatically begin running.
button is pressed, the next station in sequence will be started and the previ-
and buttons – a display number will begin flashing.
and buttons again to enter the number.
button repeatedly. The display number
or but-
7