Important - Bullerjan B3 Keramik MAX Notice De Montage

Please read these instructions carefully before starting the
installation!
We strongly recommend that the installation is always carried out by two
people and by trained specialist personnel.
Furthermore, the following points must be observed during installation:
- Rubberised work gloves should be worn
- Always tighten all screw connections of the ceramic only hand tight
- Always place the ceramics on a soft surface and place them on a
- The stove must be aligned horizontally before installing the ceramic.

IMPORTANT:

If you want to use the flue gas outlet at the back of the stove, the flue gas pipe
must be converted and the stove pipe connected before the ceramic cladding is
fitted. Furthermore, the rear wall of the stove must already be hung over the
stovepipe at this stage so that it can be fitted to the stove later.
For the assembly you need the following tools:
• 13 mm open-end spanner
• 10 mm open-end spanner
• 1 x ratchet with 13 mm nut
• 4 Allen key
• 3 Allen key
• Medium-sized slotted screwdriver
• Spirit level
Screws (included in delivery - please check for completeness):
• 10 x washer
• 10 x slotted set screw (M6 x 30)
• 12 x hexagon socket round head screw (M6 x 16)
• 2 x hexagon socket round head screws (M5 x 10)