First Steps; Network Requirements; Preparing The Network; Navigation Through Menus - Albrecht Audio DR 450 Mode D'emploi

1. First steps

1.1. Network requirements

Before using the DR 450, the following requirements must be met:
● Broadband connection with a wireless access point, router or similar network device.
● The network device must support WLAN (802.11b/g/n) wireless connection.
● If you want to remotely control the DR 450 via DLNA, you will need a PC or smartphone
connected to the same network as the DR 450.

1.2. Preparing the network

• Establish a WLAN connection as follows:
• Make sure that the WLAN indicator on the wireless access point or router is lit.
Please refer to the corresponding user manual for further information.
Please note: WLAN allows data transmission over short distances up
to 20 m without cables. Walls or ceilings reduce the range of the WLAN
connection. Therefore, place the DR 450 and/or the access point within
this distance as much as possible and avoid obstacles between the
devices.

1.3. Navigation through menus

With the button, you can access the main menu of the DR 450 at any time.
Use the arrow buttons ◄ ► ▲ ▼ to move through the individual menus. Always confi rm a selection
with the OK button. Use the ► button to go to the next menu and use the ◄ button to return to the
previous menu. The possible buttons are shown at the bottom right and left of the display.

1.3.1. Text entry

When you add the address of an online radio station or your wirless network key, you need to enter
text. It is the same procedure to set the time, date or the alarm.
To enter upper/lower case letters, symbols, or numbers:
1. Press the up/down navigation button to select a character from the following:
A a B b...Z z $ % & # _ ^ ~
2. Press the right navigation button ► to proceed to the next. Press the enter button when done.
NOTE: When entering numbers the numeric keys on the remote control can also be used.
、
" ', . : ; ? ! * - + @ < = > { } [ \ ] ( / ) 0 1...9
English 31