Leviton omnistat 3 Directives D'installation page 25

MENU/SUB-MENU DESCRIPTIONS - Continued
2. Status – set the operation of the status, with 3 settings:
a. Auto – this is the default setting, where the backlight comes on when any
button is pressed and remains on until no buttons have been pressed for a
minute.
b. Always OFF – the backlight will never come on.
c. Always ON – the backlight remains on all the time.
Devices – this menu item allows you to add additional Lumina RF Door/Window
contacts, Motion Detectors, and Occupancy sensors. The configurable items are:
**** The Hospitality thermostat has an onboard occupancy detector, but can also work in
combination with one or more additional Lumina RF sensors (any combination or door/
window, motion, or occupancy sensors up to 10 maximum), providing the ability to more
accurately detect occupancy. The most reliable occupancy detector is the door contact
on a typical entry/exit door. When this door is open & closed, the thermostat will go into a
pre-determined state for 10-30 minutes (configurable in the Hospitality Settings). If there
is no motion detected by the thermostat or a motion sensor, the room is determined to be
unoccupied. If motion is sensed at any point, the room is determined to be occupied and will
stay occupied until the entry/exit door is open and closed. ****
1. Find Devices – used to enroll Lumina RF Door/Window contacts, Motion
Detectors, and Occupancy sensors. Simply put the sensor into Enroll mode and
press the -/+ button (Find Device).
2. Device List – lists all of the devices currently enrolled in the Lumina RF network,
and provides the ability to select a device and disband it from the network.
Passcode Options – this menu item allows you to enable/disable the use of a
passcode, as well as to change a passcode. The configurable items are:
1. Require Passcode – can be set to Yes or No. The default value is Yes.
2. Change Passcode – used to change the passcode to access the Setup menu.
About – this menu items displays the firmware version of the thermostat. The
thermostat may also be restored to Factory Defaults by pressing the -/+ button
(Defaults) once, and then a second time to Confirm reset.
23