Argo Joy Mode D'emploi page 6

1. Place the diffuser on a flat, stable surface, away from the edge.
2. Remove the cover.
3. Fill the reservoir with mineral water (bottled water or tap water); do not exceed the maximum water level – 300 ml
(indicated by the word MAX in red letters).
4. Then add a few drops of water soluble fragrance (3-6 drops) to the water tank.
5. Replace the cover on the diffuser.
6. Plug the connecting cable into the DC-jack located on the rear of the diffuser.
7. Plug the adaptor into the power supply.
It is recommended to change the water in the reservoir frequently and to clean the diffuser regularly, especially if you wish
to change the aroma.
1. Turn off and unplug the device.
2. Remove the cover and empty the water from the reservoir. Empty the water using the water spout, on the left of the
air outlet. Do not empty the water in the air outlet, this would damage the diffuser .
3. Clean the interior of the diffuser with a soft tissue and a little water. If necessary, use some heavily diluted vinegar. Do
not use corrosive detergents. Gently wipe the ceramic disc with a cotton bud, being careful not to scratch it.
INSTRUCTIONS
A detailed diagram can be found on the last page.
MAINTENANCE
6