Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LOOSENING AND TIGHTENING OF THE VICE
•
Tighten - turn the vice rod clockwise to secure the work-piece with the vice.
Loosen - turn the vice rod counter-clockwise to release the work-piece (see Fig. 3).
•
•
When a large work-piece is being cut, move the auxillary stopper forward 3.5 mm (see Fig. 4).
•
Raise the section bar with a supporting block. Check the size of the supporting block first. Ensure
that it is smaller than the size of the section bar, so that the section bar can be secured by the vice (see
Fig. 5).
Fig. 3
CLEANING AND MAINTENANCE
1. Keep the motor-outlet well ventilated and clean. Compressed air can be used to blow off the dust in
the motor.
2. Check the bearing housing and the gearbox periodically and lubricate them occasionally.
3. After 40 hours of use, check the carbon brush for replacement. The carbon brush should be changed
when it has been worn down to 5 to 6 mm by wear (see Fig. 6).
4. Remove the brush lid with a screwdriver when checking and replacing the brush. Replace worn
brushes with a new pair. Let the motor idle for 10 minutes (see Fig. 7).
For any technical questions, please call 1-800-665-8685
Fig. 6
PARTS IDENTIFICATION
Fixed guard
Movable hood
Vice rod
Worktable
Fig. 4
Fig. 7
Side cover
Auxilary stopper
6
8085052
Supporting block
Fig. 5
Publicité
Table des Matières
