Symbols Used; Technical Data; Size Of The Logs To Be Split; Recommended Oils - Woody 505 Livret D'emploi Et D'entretien

1.1 - Symbols used

Standard graphic symbols are used on all machines in order to ensure complete safety of all parts of the log splitter. As these symbols are very
important, read the information below attentively.
It's necessary to read carefully the entire use and
maintenance manual of the machine, before using it
it is obligatory to wear safety footwear at all times to
provide protection against the risk of logs accidentally
falling on feet.
it is obligatory at all times to wear gloves which protect
the hands against chips and splinters which may be
produced during work.
it is obligatory at all times to wear goggles which protects
the eyes against chips and splinters which may be
produced during work.
The log splitter must be used by one person alone.
it is forbidden to stand in the range of action of the
machine. apart from the operator, no other person or
animal may be present within a radius of 5 metres from
the machine.

2 - TECHNICAL DATA

Lenght (mm)
Widht (mm)
Height (mm)
Weight (Kg)
Max. force (tons.)
Log capacity (mm)
Hydraulic oil capacity (Lt.)
Supply
Absorption
Power
Average noise
Vibration
Figure 3 on page 2 shows the maximum dimensions of the log splitter.
14
~ 925
~ 463
~ 1060
~ 50
~ 5
~ 520
~ 3,3
230V 50Hz single-phase
~ 12 A
2,5 Hp - 1,85 KW
<= 71 dB(A)/1m.
Protective earphones are not necessary
<= 2,5 m/s²
Dumping of used oil in the environment is forbidden. The
oil must be disposed of according to current legislation in
the country where this operation is carried out.
Danger of cutting or crushing of the hand: never touch
hazardous areas while the wedge is moving.
Warning: always pay attention to the movement of the log
pusher.
Warning: never remove a log trapped in the wedge with
your hands.
Warning: Before carrying out any maintenance operation
described in this manual, disconnect the plug of the
machine.
Warning: voltage as indicated on the rating plate
Machines fitted with electrical parts must not be disposed
of as general waste and must be separated for disposal as
separately collected fractions, deposited at authorised
collection points.

2.1 - Size of the logs to be split

Figure 2 on page 2 shows the maximum log sizes that can
be split.
The diameter of the log is indicative: a small log can be difficult
to split if it has knots or a particularly twisted fibre.

2.2 - Recommended oils

We recommend use of the following oils for the hydraulic
cylinder:
SHELL TELLUS T22
ARAL VITAM GF22
BP ENERGOL HCP22
TEXACO RANDO HDZ 22/32
MOBIL DTE11 or equivalent
DO NOT USE OTHER GRADE OILS.
ENGLISH
D22200447