Parts And Features; Installation Requirements; Location Requirements; Electrical Requirements - Haier HEN70ETFP Instructions D'installation Et Guide De L'utilisateur

PARTS AND FEATURES

a
b
c
d

INSTALLATION REQUIREMENTS

LOCATION REQUIREMENTS

•
Place the dehumidifier on a flat, level, surface to avoid
shaking, vibration and water spilling.
•
The surface must be strong enough to support the
dehumidifier when the collection bucket is full of water.
•
Maintain a minimum 8" (20 cm) clearance around the
dehumidifier to dissipate the heat properly.
20"
(51 cm)
20"
(51 cm)
•
Keep the dehumidifier free of any obstructions such as
drapes, curtains, blinds, etc.
•
Keep all windows and doors to the outside closed when
operating the dehumidifier. Humid air will increase the
dehumidifier's workload.
f
g
e
•
•

ELECTRICAL REQUIREMENTS

20" (51 cm)
20"
(51 cm)
3
h
i
Do not place the dehumidifier in an area where the
temperature will fall below 38°F (3°C). Lower
temperatures may cause a layer of frost to accumulate
which will decrease performance.
Do not place the dehumidifier in direct sunlight or near a
heat source such as baseboard heaters, stoves, etc.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
A Control Panel
B Dehumidified Dry
Air Vent
C Handle
D Water Collection
Bucket
E Casters
F Humid Air Intake
G Air Filter
H Direct Drain
Outlet
I Drain Pump
Connector