Glen Dimplex RM162 Guide Du Propriétaire page 6

INSTALLATION INSTRUCTIONS
MULTIPLE HEATERS WITH ONE THERMOSTAT
More than one heater can be wired in parallel on the same circuit breaker (be sure to check
national and local codes for safety requirements). Additional electrical supply wire and cable clamp
connectors are required, and you'll need to use a wall thermostat. When wiring multiple heaters to
one thermostat, the heaters must be in the same room and be spaced a minimum of three feet apart.
The maximum amperage load you can put on one circuit breaker is limited to either 80% of the circuit
breaker capacity, or the maximum amperage rating of the thermostat, whichever is lower.
to the wall thermostat
Figure 7 Heater #1
1. Route the electrical supply wire from the circuit breaker to the wall thermostat. At the wall can of
heater #1, remove two knockouts and attach two sets of electrical supply wires with two cable
clamp connectors (not included) leaving a minimum of 6 inches wire lead. One set of electrical
supply wire goes to the wall thermostat and the other set goes to heater #2 (See Figure 8).
2. There are two supply ground wires in the wall can of heater #1 (See Figure 7). Connect the green
ground wire in the wall can of heater #1 to each of the ground wires from each set of the supply
wires (See Figure 7).
3. For heater #1, connect each heater wire to one of the supply wires going to the thermostat, and
one of the supply wires going to the heater #2. Each of the wires from heater #1 must have a
3-wire connection.
4. For heater #2, make the connections in the wall can as shown in Figure 8 above.
5. Turn power back on at the main disconnect panel.
6. Proceed to OPERATING INSTRUCTIONS.
For more effective and safer operation and to
prolong the life of the heater, read the Owner's
Guide and follow the instructions. Failure to
properly maintain the heater will void any warranty
and may cause the heater to function improperly.
LIMITED FIVE YEAR WARRANTY: Glen Dimplex
Americas will repair or replace any RM Horizon-
tal Fan-forced Heater found to be defective within
five years after the date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2 . Damage occurs to the product through improper
maintenance, misuse, abuse, accident, or
alteration;
3. The use of unauthorized accessories or
unauthorized components
alteration and voids all warranties. Refer
to website gdaheat.com
service at 888-346-7539 for list of authorized
accessories and components.
To register your product, visit
6
to heater #2
WARRANTY
constitutes an
or call customer
Figure 8 Heater #2
4. Glen Dimplex Americas' warranty is limited to
repair or replacement.
5. In the event Glen Dimplex Americas elects
to replace any part of your product, the
replacement parts are subject to the same
warranties as the product. The installation of
replacement parts does not modify or extend
the underlying warranties. Replacement or
repair of any Glen Dimplex Americas product
or part does not create any new warranties.
If you believe your product is defective, please
contact Glen Dimplex Americas during the
warranty period, for instructions on how to have
the repair or replacement processed.
Parts and Service
Visit gdaheat.com/parts
to obtain parts and service.
gdaheat.com/register
from heater #1
for information on where