URBANGLIDE ECROSS PRO BOOST Notice Originale page 11

Lubrication
The folding system of your scooter needs to be lubricated every 6 months with a neutral non-
corrosive oil.
To enter the settings for your product, press the "+" and "-" buttons on your screen for 5 seconds.
Attention! If you change all the basic settings, you change the performance and condition of your product. We
recommend that you only change the settings below:
Menu
P01
P02
P04
P09
ERROR
E06 Check that your battery is fully charged. If so, check that the battery compartment (Tray) is not damaged. Then check the
E07
E08
E09
E10
Signal lost, check the condition of the cables in your product. This problem may be caused by the motherboard or the
E11
Signal lost, check the condition of the cables in your product. This problem may be caused by the screen.
E30
Go to the settings of your product by pressing and holding down the "+" and "-" buttons. Go to setting P20 and enter 0.
Maintenance
When the performance of your brakes starts to decrease, you can
adjust the sensitivity of your brake cables.
System settings
Adjusting the unit of measurement of the distance
0 = No sleep mode
0 = Immediate start
Error code
Check the condition of the cables in your product. Then check the condition of the motor(s).
Check that the throttle trigger is in good condition. Check the condition of your product's cables.
Check the condition of the cables in your product. Changed the motherboard.
Setting
Brightness adjustment
0 = KM 1=MILES
Screen saver time
1 to 60 = The number of minutes of standby time
Start-up mode
1 = Impulse to start
PROBLEM
Battery
condition of your product's cables.
Motor
Accelerator
Motherboard
Reception cable
display.
Transmission cable
Communication error
11
Brakes