SNOWJOE SUNJOE SPX200E Manuel D'utilisation page 8

4. Fit the spray wand assembly into the gun and turn the
rotatable end-piece of the wand until the two parts are
completely locked (Fig. 4).
Fig. 4
Spray wand assembly
5. Connect the quick-connect end of the high-pressure hose
to the trigger gun (Fig. 5). You will hear a click when it
snaps into place. To release the high-pressure hose from
the trigger gun, push the release button on the trigger gun.
Fig. 5
Push to release
High-pressure hose
6. Connect the other end of the high-pressure hose to
the water outlet on the pressure washer (Fig. 6). First,
push the high-pressure hose end completely onto the
high-pressure water outlet, then screw it on clockwise.
Fig. 6 (BACK)
High-pressure hose
Water outlet
WARNING!
hoses may cause injury. Examine hoses regularly and replace if
damaged. Do not attempt to mend a damaged hose.
7. Connect the garden hose adapter (female coupler) to the
water inlet of the pressure washer, then thread your garden
hose (male end) into the garden hose adapter
Trigger gun
The garden hose must have an internal diameter of at least
13 mm (1/2 in.) and must be reinforced. The water supply
must be at least equal to the washer delivery capacity.
NOTE: The machine is not suitable for connection to
RELEASE
the potable water main.
Fig. 7 (FRONT)
Garden hose
Garden hose
RELEASE
8. Attach garden hose to water supply (Fig. 8).
Trigger gun
Fig. 8
WARNING!
WARNING!
system, the system shall be protected against backflow
WARNING!
not exceed 104ºF/40ºC. The water supply must not
exceed 0.7 MPa.
CAUTION!
use of unfiltered water containing corrosive chemicals will
damage the washer.
8
Keep hose away from sharp objects. Bursting
This end to
(male end) water inlet
Water inlet
Connect to water supply
Garden hose
Do not connect to portable water system.
If connection is made to a portable water
The intake water temperature must
The washer must only be used with clean water;
(Fig. 7).