Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Carefully unpack unit and examine all packaging to be sure all parts are
included.
2.
Place unit on a flat and stable surface.
3.
Be sure On/Off switch is "OFF" position (button is up).
4.
check that the Blade is secure and Blade Locking screw is in LOCK position.
To "lock" turn screw one quarter turn counter-clockwise.
5.
Always keep the Blade Guard covering the Blade until ready to use. BLADE
IS SHARP - ALWAYS HANDLE WITH CARE!
6.
Check that the Locking Bolts are secure. To tighten, turn clockwise. For the
Lower Locking Bolt use the handle from the Upper Bolt as a tool.
1.
Remove Slicing Guard and Food Carriage by tilting carriage bed away from
Motor Assembly.
2.
Remove the Blade Guard and Blade Locking Screw by turning clockwise
one-quarter turn. Carefully pull the Blade off and hold by using the center of
blade.
3.
Remove the Upper Locking Bolt by turning counter-clockwise.
4.
Gently lay the unit on its back, this will give access to the Lower Locking
Bolt.
5.
Remove Lower Locking bolt using the end of the Upper Bolt as a tool.
6.
Lift unit to upright position, support Motor Assembly while lifting.
7.
Hold firmly and lift Motor Assembly upward to remove.
8.
Reverse steps to assemble.
ASSEMBLY INSTRUCTIONS
REMOVE MOTOR ASSEMBLY
Upper Locking Bolt
Lower Locking Bolt
4
Publicité
Table des Matières
